Purpose: To set parking radar volumes.
Procedure:
1 – With the engine off and the ignition switched off, connect your official VAG-COM VCDS cable to the computer, then connect the other end to your vehicle’s diagnostic port.
2 – Switch on the ignition and run the VCDS program.
Line 1 (Radar Front) :
3 – Click on“Select”, then click on“76 – Stationnt help”.
4 – Click “Adaptation 10.”
5 – Channel 01 ( Choose the new value according to the desired volume, between 0 and 100% )
Line 2 (Rear Radar):
3 – Click on“Select”, then click on“76 – Stationnt help”.
4 – Click “Adaptation 10.”
5 – Channel 02 ( Choose the new value according to the desired volume, between 0 and 100% )
This post is also available in:
Français (French)
