Purpose: Enables the ambient lighting. (After installing the wiring and lighting for an aftermarket installation)
Procedure:
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
Line 1: Activating the ambient lighting:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Coding 07”.
5 – Select the “0” module and click on “Long Coding Helper”:
Byte 20:
Bit 0: Check “Footwell Lights installed”
Line 2 Ambient Lighting Settings:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click “Adaptation 10.”
5 – Channel 27 “Footwell Lighting Dimming (with Open Door)”
Mettre une valeur entre 0 et 200 (pour un éclairage à 100%, mettre 200)
Line 3: Turning on the ambient lighting while driving:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Coding 07”.
5 – Select the “0” module and click on “Long Coding Helper”:
Byte 12:
Bit 5: Check “Footwell Lights with Terminal 58d active”
Line 4: Adjusting the ambient lighting while driving:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click “Adaptation 10.”
5 – Channel35 “Footwell Lighting Dimming (with Terminal 58d)”
Mettre une valeur entre 0 et 200 (pour un éclairage à 100%, mettre 200)
This post is also available in:
Français (French)
