Purpose: Allows you to share the connection received by the car from a phone or a 4G dongle via a hotspot. For Columbus V1 MIB1 models with firmware version MHIG only.
Warning!! There are 4 lines of code to enter here.
Procedure:
1 – With the engine off and the ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostic port.
2 – Turn on the ignition, then launch the VCDS program.
Line 1:
3 – Click on“Select” then click on“5F – Electr. information”.
4 – Click “Security Access – 16,” then enter the code “20103“
5 – Click on“Adaptation – 10”.
6 – On this page, at the top, there is a drop-down menu.
In this drop-down menu, choose“WLAN”.
7 – On this same page, there is a second drop-down menu at the bottom
of the page.
On this menu, choose the value“ON”.
Line 2:
3 – Click on“Select” then click on“5F – Electr. information”.
4 – Click on “Security Access – 16,” then enter the code “20103“
5 – Click on “Adaptation – 10“
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “Vehicle Configuration – Wi-Fi Hotspot“
7 – On this same page, there is a second drop-down menu at the bottom
of the page.
On this menu, choose the value“ON”.
Line 3:
3 – Click on“Select” then click on“5F – Electr. information”.
4 – Click “Security Access – 16,” then enter the code “20103“
5 – Click on“Adaptation – 10”.
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose“Vehicle configuration-UPnP”.
7 – On this same page, there is a second drop-down menu, but it’s further down
on the page.
On the latter, select the value ” ON “
Line 4:
3 – Click on ” Select ” then click on ” 5F – Information Electr. “.
4 – Click on ” Coding- 07 ” then click on “”Long Encoding Assistant“
5 – Select byte “15“
Then check bit “4“
6 – Select byte “24“
Then check bit “3“
This post is also available in:
Français (French)
