Purpose: Displays guide lines on the Park Assist Amundsen MIB2 screen to show the vehicle’s path during parking maneuvers.
Proceed :
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
Line 1:
3 – Click “ Select,” then click “ 10 – Parking Assistance.”
4 – Click on “Security Access – 16,” then enter the code “71679“
5 – Click on “Coding – 07,” then click on “Long Coding Helper“
6 – Select byte “01“
Then check bit “5“: “Vehicle Path Display active/enabled“
This post is also available in:
Français (French)
