Purpose: Allows you to disable freewheel mode (Sailing / Freilauf) on vehicles equipped with a DSG transmission. This coding allows you to modify the control of the freewheel function, which disengages the engine from the transmission during deceleration to reduce fuel consumption.
Procedure:
1 – With the engine off and the ignition off, connect your official VAG-COM VCDS cable to the computer, then connect the other end to your vehicle’s diagnostic port.
2 – Turn on the ignition, then launch the VCDS program.
Line 1:
3 – Click on“Select”, then click on“19 – Gateway“.
4 – Click on “Coding – 07”.
5 – Click on “Long Coding Helper” .
6 – Select Byte 09
Disable bit 4 “FPA_Funktion_Freilauf_DefaultON”
Line 2:
3 – Click on“Select”, then click on“19 – Gateway“.
4 – Click on “Coding – 07”.
5 – Click on “Long Coding Helper” .
6 – Select Byte 12
Set bit 2 to 0 “FPA_Function_Free-Wheel” / “Drive Program Function ‘Free Wheel/Clutch’ active”
Line 3 (if you have Front Assist):
3 – Click “Select,” then click “13 – Distance Control.”
4 – Click on “Coding – 07”.
5 – Click on “Long Coding Helper” .
6 – Select Byte 11
Select bits 6-7 “Sailing_function – not active”
OBDeleven: “Sailing_function” “no_predictive_sailing”
This post is also available in:
Français (French)
