Purpose: Allows the sunroof to open fully when using the “Comfort Open” function with the remote control.
Procedure:
1 – With the engine off and the ignition switched off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostic port.
2 – Turn on the ignition, then launch the VCDS program.
Line 1:
3 – Click “Select,” then click “CA – Sunroof.”
4 – Click on“Security Access – 16” then enter the code“20103”.
5 – Click on“Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “Target position for comfort opening” / “Komfortfunktionen-Ziellage bei Komfortöffnen“
7 – On this same page, there is a second drop-down menu, but further down
.
From this menu, select “Sliding position ” then click Submit.
This post is also available in:
Français (French)
