
Purpose: to activate the ambient lighting retrofitted to the driver/passenger door and rear doors (retrofit). The ambient lighting retrofitted to the doors can therefore be dimmed via the MMI input (similar to floor lighting).
Mood lighting must be activated! ( see tutorial: Activate mood lighting )
Procedure:
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
Line 1:
3 – Click “Select,” then click “42 – Electronic Door Control Module“.
4 – Click “ Encoding – 07,” then click “Long Coding Helper.”
5 – Select Byte 1:
Bit 1
Line 2:
3 – Click “Select,” then click “52– front passenger door electronics.”
4 – Click “ Encoding – 07,” then click “Long Coding Helper.”
5 – Select Byte 1:
Bit 1
Line 3:
3 – Click “Select,” then click “62 – Left rear door electronics“.
4 – Click “ Encoding – 07,” then click “Long Coding Helper.”
5 – Select Byte 1:
Bit 1
Line 4:
3 – Click “ Select,” then click “72 – Right Rear Door Electronics.”
4 – Click “ Encoding – 07,” then click “Long Coding Helper.”
5 – Select Byte 1:
Bit 1
This post is also available in: