Purpose: Allows the sunroof to open fully when opening with the remote control.
Proceed :
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
Line 1:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click “Security Access – 16,” then enter the code “31347” or “48396”
5 – Click on“Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “Zugangskontrolle 2-SAD Komfort schliessen.”
7 – On this same page, there is a second drop-down menu toward the bottom
.
From this menu, select “Active” and then confirm.
Line 2:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click “Security Access – 16,” then enter the code “31347” or “48396”
5 – Click on“Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “Zugangskontrolle 2-SAD Komfort oeffnen.”
7 – On this same page, there is a second drop-down menu toward the bottom
.
From this menu, select “Active” and then confirm.
Line 3 (Optional, to open the sunroof completely):
3 – Click “Select,” then click “CA – Sunroof.”
4 – Click on“Security Access – 16” then enter the code“20103”.
5 – Click on“Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “Target position for comfort opening” / “Komfortfunktionen-Ziellage bei Komfortöffnen“
7 – On this same page, there is a second drop-down menu, but further down
.
From this menu, select “Sliding position ” then click Submit.
