Purpose: Automatically lowers the passenger-side rearview mirror when reversing.
The mirror adjustment button must be in the “R” position, and the feature must be enabled on the Columbus/Amundsen for the passenger-side mirror to lower automatically.
Warning!! There are 3 lines of code to write here.
Procedure:
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
Line 1:
3 – Click on“Select”, then click on“52 – Passenger door“.
4 – Click on“Coding – 07“, then on“Long Coding Helper“.
5 – Select byte “4“
Then check bit “2“: “Reserve Gear Mirror Dipping active“
and bit “3“: “Position Memory for Reserve Gear Mirror Dipping active“
Line 2:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click “Security Access – 16,” then enter the code “31347.”
5 – Click on“Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “Access Control 2-Spieglelabsenkung bei Rueckwaertsfahrt“
7 – On this same page, there is a second drop-down menu near the bottom of the page.
From this menu, select “active” and then confirm.
Line 3:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click “Security Access – 16,” then enter the code “31347.”
5 – Click on“Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “Access Control 2-Menuesteuerung Spieglelabsenkung.”
7 – On this same page, there is a second drop-down menu near the bottom of the page.
From this menu, select “active” and then confirm.
This post is also available in:
Français (French)
