Purpose: to activate/deactivate the daytime running lights (DRL) from the Amundsen/Columbus.
BE AWARE of your country’s regulations and vehicle inspection requirements regarding daytime running lights!
However, if you’re coding in your car to avoid using too much of your battery, this is a good solution…
Proceed :
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
Line 1:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on“Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
In this drop-down menu, select “Daytime running lights—Tagfahrlicht—Activation possible via BAP or control sequence.”
7 – On this same page, there is a second drop-down menu at the bottom
of the page.
On this menu, select“active” and confirm.
OBDeleven:
This post is also available in:
Français (French)
