Purpose: Allows you to enable Coming / Leaving Home without the light sensor.
Warning! There are 5 lines of coding to do here.
Proceed :
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
Line 1:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on“Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “Comfort Illumination—Coming Home Status.”
7 – On this same page, there is a second drop-down menu, but further down
.
In this menu, (2 options):
- Select the “manual” setting: You’ll need to flash your headlights before pulling over.
- Select the “automatic” setting: The headlights will turn on every time you open the driver’s door. “See (5)”
Then click “Submit.”
Line 2:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on“Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “Comfort Lighting – Menu Control – Coming Home – Factory Settings.”
7 – On this same page, there is a second drop-down menu toward the bottom
.
From this menu, select “active” to display the CH/LH settings on the car stereo.
Then confirm.
Line 3:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on“Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “Comfort lighting—Coming Home 10 s menu setting.”
7 – On this same page, there is a second drop-down menu located toward the bottom
.
In this menu, enter the desired value for a duration between “0” and “60“—the value is expressed in seconds.
Then click “Confirm.”
Line 4:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on“Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “Comfort Illumination—Coming Home Lights, Low Beam/Fog Light.”
7 – On this same page, there is a second drop-down menu located toward the bottom
.
In this menu, set the value to “Low beam” for the low beams and “Fog Light” for the fog lights.
Line 5:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on“Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
In this drop-down menu, select “Comfort Lighting—Coming-Home Activation Event: Driver’s Door/Ignition Key.”
7 – On this same page, there is a second drop-down menu, but further down
.
In this menu, (2 options):
- Select the “driver door” option so that the CH/LH function activates when the driver’s door is opened.
- Select the “Ignition key” option so that the CH/LH occurs when the key is removed.
Then click “Submit.”
This post is also available in:
Français (French)
