Purpose: Allows you to add Apple CarPlay and Android Auto to Full Link after it has been enabled on MIB2 systems with 2xxT part numbers, when only MirrorLink appears in the Full Link menu.
For the firmware reference:
MST2_EU_SE_ZR_P02XXT
–> Full Link CarPlay and Android Auto Activation
–> Disable MirrorLink
–> Enable the USB port for iPhone CarPlay (retrofit)
Proceed :
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
Line 1:
3 – Click on“Select” then click on“5F – Electr. information”.
4 – Click on“Security Access – 16” then enter the code“20103“.
5 – Click on“Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “Vehicle Configuration – Apple_DIO“
7 – On this same page, there is a second drop-down menu located toward the bottom
.
From this menu, select “Enabled” and then confirm.
Line 2:
3 – Click on“Select” then click on“5F – Electr. information”.
4 – Click on“Security Access – 16” then enter the code“20103“.
5 – Click on“Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “Vehicle Configuration – Google_GAL.”
7 – On this same page, there is a second drop-down menu further down
.
From this menu, select “Enabled” and then confirm.
