Purpose: Allows you to adjust the speed thresholds for turning the corner lights on and off via the fog lights. (Corner Lights)
Warning! There are 2 lines of coding to do here.
Proceed :
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to
the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
Line 1 (Turn Signal Activation Speed):
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on“Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “statisches Kurvenlicht-Untere Geschwindigkeitsschwelle.”
7 – On this same page, there is a second drop-down menu located toward the bottom
.
In this menu, adjust the value accordingly and then confirm. (Default value: 0 km/h)
Note: When this value is specified, the turn signals are turned off when the vehicle is stationary and are activated only once the corresponding set speed is reached.
Line 2 (Turn Signal Fade-Out Speed):
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on “Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “statisches Kurvenlicht-Obere Geschwindigkeitsschwelle.”
7 – On this same page, there is a second drop-down menu located toward the bottom
.
In this menu, adjust the value as needed and then confirm. (Default value: 32 km/h)
Note: This is probably a good idea up to a maximum speed of 60 km/h (in urban areas), because otherwise the cornering lights will also be activated on country roads if the steering angle is sufficient.
This post is also available in:
Français (French)
