Purpose: Enables the high-beam assist feature for vehicles equipped with the Sign Assist or Lane Assist options. (High Beam Assist for xenon headlights)
The vehicle must be equipped with the camera Ref 5Q0: 5Q0-980-653-E (A3 8V phase 1, the camera is located at the top of the windshield at the level of the rear-view mirror, in the shape of a triangle).
Please note: If the vehicle is equipped with DLA (Dynamic Light Assist), coding is not possible (Light Assist is already enabled on the automatic headlights).
Watch out! There are 4 lines of coding to do here.
Proceed :
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to
the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
Line 1:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Coding – 07” then click on“Long Coding Helper“.
5 – Select byte “2“.
Then, in the “Bit 0-2” drop-down menu, select “03 Lighting: Bi-Xenon Headlights with Light Assist (PR-8IG/8IP+8G1)“
Line 2:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on “Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “Assistance light functions—Menuesteuerung Femlichtassistent.”
7 – On this same page, there is a second drop-down menu toward the bottom
.
From this menu, select “present” and then confirm.
Line 3:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on“Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
In this drop-down menu, select “Light Functions Assistance—Menu Control, Female Light Assistant, Factory Settings.”
7 – On this same page, there is a second drop-down menu toward the bottom
.
From this menu, select “present” and then confirm.
Line 4:
3 – Click on“Select” then click on “.A5 – Frt Sens. Drv. Assist “.
4 – Click on“Security Access – 16” then enter the code“20103”.
5 – Click “Encoding – 07,” then click “Long Coding Helper.”
6 – Select byte “2“
Then, in the “Bit 0-7” drop-down menu, select “01 Coding_Light_Assist High_Beam_Assist“
This post is also available in:
Français (French)
