
Purpose: Resolves the ODB error after installing LED backup lights.
Watch out! There are 4 lines of coding to do here.
Proceed :
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to
the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
Line 1:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on“Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “Leuchte29RFL RA64 – Lasttyp 29“
7 – On this same page, there is a second drop-down menu toward the bottom
.
From this menu, select “43 – allgemeine LED” and then confirm.
Line 2:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on “Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “Leuchte29RFL RA64 – Dimmwert AB29″
7 – On this same page, there is a second drop-down menu further down the page
.
From this menu, select “127” and then confirm.
Line 3:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on“Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
From this drop-down menu, select “Leuchte28RFL LC11 – Lasttyp 28“
7 – On this same page, there is a second drop-down menu toward the bottom
.
From this menu, select “43 – allgemeine LED” and then confirm.
Line 4:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on “Adaptation – 10”.
6 – At the very top of this page, there is a drop-down menu.
In this drop-down menu, select “Leuchte28RFL LC11– Dimmwert AB28″
7 – On this same page, there is a second drop-down menu further down
the page.
From this menu, select “127” and then confirm.
This post is also available in: