Audi Q2 GA (2016+ ) / Audi SQ2
Q2 (GA) – ACC distance setting in MMI
Purpose: for convenient adjustment of ACC distance setting via MMI. Procedure: 1 - Engine off, ignition off, connect your official VAG-COM VCDS...
Q2 (GA) – Activate a second phone via Bluetooth
Purpose: Allows you to connect two phones simultaneously via Bluetooth to the MMI if you don't have the Audi Phone Box option....
Q2 (GA) – Activate auto-school mode
Purpose: Adds a driving-school mode view to the MMI, displaying turn signals, speed, etc. (also ideal for accompanied driving). Warning! There are...
Q2 (GA) – Activate daytime running lights (DRL) only in Auto position
Purpose: to activate daytime running lights (DRL) only when the headlight control knob is in the auto position. Proceed : 1 -...
Q2 (GA) – Activate G-Meter
Purpose: Adds the G-Meter (Accelerometer) to the Virtual Cockpit screen. Proceed : 1 - Engine off, ignition off, connect your official VAG-COM...
Q2 (GA) – Activate heated mirrors (retrofit)
Purpose: to activate heated/defrosting mirrors after retrofitting. Proceed : 1 - Engine off, ignition off, connect your official VAG-COM VCDS cable to...
Q2 (GA) – Activate intruder alarm with horn
Purpose: to activate an alarm with horn in the event of intrusion into the vehicle, and to lock the vehicle if the...
Q2 (GA) – Activate Lane Assist memory function
Purpose: to store the Lane Assist function in memory. If you deactivate it, the Lane Assist will not automatically resume the next...
Q2 (GA) – Activate reversing camera (retrofit)
Purpose: To activate the reversing camera after it has been installed on the MMI (camera retrofit Low or High). Procedure: 1 -...
Q2 (GA) – Activate trailer coupling (retrofit)
Purpose: Enables trailer / towbar retrofit. Watch out! Adaptation in motor control unit 01 is not accepted for some models. In this...
Q2 (GA) – Activate window operation with ignition off
Purpose: activates window operation (close/open) with ignition off and door open. Proceed : 1 - Engine off, ignition off, connect your official...
Q2 (GA) – Activate/deactivate daytime running lights (DRL) via MMI
Purpose: to activate/deactivate the daytime running lights (DRL) from the MMI. ATTENTION to your country's regulations and technical inspection for daytime running...
Q2 (GA) – Activation of progressive interior lighting
Purpose: turns interior lights (door knobs, dashboard, center console) on and off gradually. By default, interior lights are switched on and off...
Q2 (GA) – Adjust Soundaktor volume
Purpose: to adjust/deactivate the volume of the Soundaktor (speaker built into the windscreen bay to simulate a false engine noise). If you...
Q2 (GA) – Automatic door unlocking with DSG in “P” position
Purpose: automatically unlocks all doors when the DSG automatic gearbox is shifted to “P”. Procedure: 1- Engine off, ignition off, connect your...
Q2 (GA) – Automatic folding of mirrors
Purpose: Automatically folds mirrors when vehicle is locked. The vehicle must be equipped with the “Electrically folding mirrors (with comodo in door)”...
Q2 (GA) – Automatic window closure in the event of rain
Purpose: Automatically closes windows and sunroof when it rains. Watch out! There are 4 lines of coding to do here. Proceed :...
Q2 (GA) – Comfort flashing light
Purpose: to set the number of flashes for the “Comfort flashing” option. Proceed : 1 - Engine off, ignition off, connect your...
Q2 (GA) – Coming Home automatic
Purpose: Automatically activates the Coming Home function (no need to make a headlight call). Proceed : 1 - Engine off, ignition off,...
Q2 (GA) – Correction of ODB consumption display
Purpose: to correct the fuel consumption display on the Trip Computer/Virtual Cockpit. Note: these changes affect the display of instantaneous consumption, average...
Q2 (GA) – Daytime running light deactivation (DRL) using the handbrake
Purpose: to deactivate the daytime running lights (DRL) using the handbrake. Proceed : 1 - Engine off, ignition off, connect your official...
Q2 (GA) – Deactivate “Switch on low beam” message
Purpose: to deactivate the low beam warning message/dialogue when the headlight switch is in position 0. Proceed : 1 - Engine off,...
Q2 (GA) – Deactivate audio reduction for parking assistance
Purpose: deactivates sound reduction when reverse gear is engaged or parking aid is activated manually. Procedure: 1 - Engine off, ignition off,...
Q2 (GA) – Deactivate horn without ignition
Purpose: deactivates or activates the horn when the ignition is off. Proceed : 1 - Engine off, ignition off, connect your official...
Q2 (GA) – Deactivate open door alarm with contact
Purpose: to deactivate the alarm which is triggered when the door is opened and the contact is in position P. Procedure: 1...
Q2 (GA) – Deactivate rear fog light warning
Purpose: to deactivate the warning message on the dashboard, which will remind you to turn on the rear fog lights when you...
Q2 (GA) – Deactivate right-hand overtaking prevention
Purpose: to deactivate the ACC lane assist system, e.g. when on the freeway and there is a traffic jam in the left...
Q2 (GA) – Deactivate/activate electric handbrake for rear brake pad change
Purpose: to deactivate/activate the electric handbrake in maintenance mode in order to change/replace the rear brake pad/disc linings. (Lining change mode) Proceed...
Q2 (GA) – Deactivation of Audi Parking System engagement beep
Purpose: deactivates the beep when the Audi Parking System is engaged. Procedure: 1 - Engine off, ignition off, connect your official VAG-COM...
Q2 (GA) – Disable AM frequency on the MMI
Purpose: to deactivate the MMI's AM radio frequency (AM radio frequency is rarely used, unlike FM radio frequency). Procedure: 1 - Engine...
Q2 (GA) – Door lock/unlock confirmation (beep/horn)
Purpose: to set confirmation of door locking/unlocking with beep (alarm) or horn. Attention! There are 5 lines of coding here, see 6....
Q2 (GA) – Electronic differential lock (XDS)
Purpose: to set the electronic differential lock (XDS) The Electronic Differential Lock (XDS) is an extension of the familiar EDS function.XDS does...
Q2 (GA) – Enable CD/DVD extraction
Purpose: activates the function for copying multimedia data (music, films, etc.), similar to the SD card function. Allows you to import /...
Q2 (GA) – Flash mode lights during emergency braking
Purpose: activates flashing lights during emergency braking. Proceed : 1 - Engine off, ignition off, connect your official VAG-COM VCDS cable to...
Q2 (GA) – Headlamp washer settings (Xenon)
Purpose: to manage the number of manual activations before the headlamp washer is activated on Xenon / to set the delay time...
Q2 (GA) – Hill Start Assist
Purpose: to set Hill Start Assist operation. (hill-start assist) Proceed : 1 - Engine off, ignition off, connect your official VAG-COM VCDS...
Q2 (GA) – Increase distance between curb and car (Park Assist)
Purpose: to set the distance between the kerb and the car during Audi Park Assist. Proceed : 1 - Engine off, ignition...
Q2 (GA) – Increase gas pedal sensitivity
Purpose: to increase accelerator pedal sensitivity. (better acceleration response with S Tronic, more significant than with manual). Proceed : 1 - Engine...
Q2 (GA) – Key operation with ignition on
Purpose: Allows you to use the key and lock the vehicle with the ignition switched on or the engine running. (Very practical...
Q2 (GA) – KEYLESS GO automatic keyless entry
Purpose: automatically locks the vehicle when you leave it with the key, provided KEYLESS Go (keyless entry/locking and starting system) is installed....
Q2 (GA) – Lane Assist activation
Purpose: to activate Lane Assist for vehicles with Sign Assist and/or Light Assist options. The vehicle must be equipped with the 3Q0...
Q2 (GA) – Lane Assist settings
Purpose: Adjusts lane departure warning, driver inactivity deactivation threshold, steering assist intensity and steering wheel vibration intensity. Procedure: 1 - Engine off,...
Q2 (GA) – Lap Timer
Purpose: to add the stopwatch to the ODB/Virtual Cockpit. Proceed : 1 - Engine off, ignition off, connect your official VAG-COM VCDS...
Q2 (GA) – License plate illumination, open trunk
Purpose: turns on license plate illumination when trunk / tailgate is open. Warning! There are 3 lines of coding to do here....
Q2 (GA) – Light Assist activation
Purpose: to activate the high beam assistant for vehicles with Sign Assist and/or Lane Assist options. The vehicle must be equipped with...
Q2 (GA) – Light Assist always active
Purpose: automatically activates the high beam assistant on start-up if it was active before the ignition was switched off. Proceed : 1...
Q2 (GA) – Lower passenger mirror when reversing
Purpose: automatically lowers the passenger mirror when reversing. The mirror adjustment knob must be in position“R” for the passenger mirror to lower...
Q2 (GA) – Make-up quantity displayed on ODB
Purpose: Displays the amount of fuel used since refueling on the ODB/Virtual Cockpit. Proceed : 1 - Engine off, ignition off, connect...
Q2 (GA) – Memory for heated seats
How it works : When you switch on the heated seat(s), as soon as you remove the key from the ignition the...
Q2 (GA) – Microphone sensitivity adjustment
Purpose: to adjust the intensity of the hands-free system's microphone. Proceed : 1 - Engine off, ignition off, connect your official VAG-COM...
Q2 (GA) – Mirror folding adjustment with remote control
Purpose: to set the mirror folding option via remote control when locking the vehicle. The vehicle must be equipped with the “Electrically...
Q2 (GA) – Needle check
Purpose: to activate the scanning of the speedometer needles when the car is started. (Works with Virtual Cockpit) (Needle Sweep) Proceed :1...
Q2 (GA) – Oil temperature on ODB
Purpose: to display oil temperature on the ODB/Virtual Cockpit. Proceed : 1 - Engine off, ignition off, connect your official VAG-COM VCDS...
Q2 (GA) – Panel display on ODB / Virtual Cockpit
Purpose: displays speed limit signs on the ODB/Virtual Cockpit (Sign Assist) Vehicle must be equipped with 3Q0 camera Warning! There are 9...
Q2 (GA) – Rear lights activated with daytime running lights (DRL)
Purpose: activates rear lights activated with daytime running lights (Scandinavian DRL) (This method activates the dashboard lighting) Proceed : 1 - Engine...
Q2 (GA) – Reprogramming a new battery
Purpose: to reprogram / recode the new battery of all its data after replacement. Watch out! There are 4 lines of coding...
Q2 (GA) – Seat heater reduction time setting
Purpose: to set the value in minutes of the heating reduction time for heated seats. As a general rule, Audi vehicles reduce...
Q2 (GA) – Set ACC control in 1 km/h increments
Purpose: to adjust the ACC distance setting from the factory setting so that it can be set in 1 km/h increments by...
Q2 (GA) – Speed of radar (or reversing camera) deactivation
Purpose: Selects the speed at which the radar and/or reversing camera are deactivated. Proceed : 1 - Engine off, ignition off, connect...
Q2 (GA) – Speed threshold settings for cornering light activation
Purpose: to set the speed thresholds for turning on and off the cornering lights via the fog lights. (Corner Lights) Warning! There...
Q2 (GA) – Start/Stop deactivation
Purpose: to disable Start and Stop completely. Watch out! There are 1 or 2 lines of coding to do here, depending on...
Q2 (GA) – Suppress belt alarm
Purpose: to suppress the audible alarm and warning light in the Virtual Cockpit when driving without a seatbelt. Proceed : 1 -...
Q2 (GA) – Switch on Corner Lights in reverse
Purpose: to activate the Corner Light (AFS) when reversing. Procedure: 1 - Engine off, ignition off, connect your official VAG-COM VCDS cable...
Q2 (GA) – Third brake light on if trunk is open
Purpose: to keep the 3rd brake light on if the trunk is not fully closed. For security lighting at night or to...
