VW Touran 2 (1T3) (2010-2015)
Touran (1T3) – Activate Bluetooth on RNS 315
Purpose: to activate Bluetooth on the RNS 315. ATTENTION: Not all RNS-315 are equipped with a Bluetooth module. Module compatibility list3C0 035...
Touran (1T3) – Activate daytime running lights (DRL) only with headlight switch in Auto position
Purpose: to activate daytime running lights (DRL) only when the light switch is in Auto position. Procedure: 1 - Engine off, ignition...
Touran (1T3) – Activate daytime running lights with fog lamps (DRL)
Purpose: Allows fog lamps to be used as daytime running lights. Procedure: 1 - Engine off, ignition off, connect your official VAG-COM...
Touran (1T3) – Activate Driving School mode (RCD 210/RCD 310)
Purpose: Allows you to add a Driving School mode view to the RCD 210, RCD 310 that displays turn signals, speed ......
Touran (1T3) – Activate headlamp washers
Purpose: to activate the headlamp washers. Procedure : 1 - Engine off, ignition off, connect your official VAG-COM VCDS cable to the...
Touran (1T3) – Activate mood lighting
Purpose: to activate ambient lighting. Procedure : 1 - Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer,...
Touran (1T3) – Activate rearview camera (retrofit)
Purpose: to activate the reversing camera after installation on the RCD 510/330/360/440 and RNS 315/510 (retrofit). Proceed : 1 - Engine off,...
Touran (1T3) – Activate RNS 510 (retrofit)
Purpose: To enable installation of the RNS 510 to replace the original RCD-310 (retrofit). Procedure: 1 - Engine off, ignition off, connect...
Touran (1T3) – Activate RNS 510 voice control
Purpose: to activate voice control on the RNS 510 (SDS). ATTENTION: RNS 510 firmware must be version v2660. Activating voice control brings...
Touran (1T3) – Activating Coming / Leaving Home
Purpose: to activate Coming Home and Leaving Home. And add it to the ODB (MFA) Procedure: 1 - Engine off, ignition off,...
Touran (1T3) – Adapting brake assist
Purpose : to configure brake assist. Procedure : 1 - Engine off, ignition off, connect your official VAG-COM VCDS cable to the...
Touran (1T3) – Add daytime running lights (DRL) to ODB
Purpose: to add daytime running light (DRL) settings to the ODB (on-board computer). Procedure : 1 - Engine off, ignition off, connect...
Touran (1T3) – Adjusting the volume of the reversing beep
Purpose: to adjust the volume of the reversing beep. Procedure : 1 - Engine off, ignition off, connect your official VAG-COM VCDS...
Touran (1T3) – Automatic closing of windows and roof in case of rain
Purpose: Automatically closes windows and sunroof when it rains. The vehicle must be locked with the remote control for this to work....
Touran (1T3) – Automatic door locking
Purpose : to set automatic door locking from 15km/h. Procedure: 1 - Engine off, ignition off, connect your official VAG-COM VCDS cable...
Touran (1T3) – Automatic door unlocking
Purpose: to set automatic door unlocking when the key is removed. Procedure: 1 - Engine off, ignition off, connect your official VAG-COM...
Touran (1T3) – Automatic headlamp activation from 140 km/h
Purpose: to automatically switch on the lights when the vehicle is travelling at over 140 km/h. (The lights will automatically go out...
Touran (1T3) – Automatic headlamp activation in case of rain
Purpose: to automatically turn on the lights when it's raining and the wipers have been triggered. Procedure : 1 - Engine off,...
Touran (1T3) – Automatically folding mirrors
Purpose: Automatically folds mirrors when vehicle is locked. For 4th generation door modules (models from 2013) activation is possible with Vag-Com VCDS...
Touran (1T3) – Brake assist
Purpose : to configure brake assist. Procedure : 1 - Engine off, ignition off, connect your official VAG-COM VCDS cable to the...
Touran (1T3) – Change the RCD/RNS 510 theme
Purpose: to change the display theme of the RCD 510 and RNS 510. Procedure: 1 - Engine off, ignition off, connect your...
Touran (1T3) – Changing the image of the RCD/RNS OPS
Purpose: to change the vehicle image of the OPS (parking aid) on the RCD 510/330/360/440 and RNS 315/510. Procedure: 1 - Engine...
Touran (1T3) – Closing windows after door opening
Purpose: Closes windows and sunroof after removing key and opening door. Procedure: 1 - Engine off, ignition off, connect your official VAG-COM...
Touran (1T3) – Comfort blinker
Purpose: to set the number of flashes for the “Comfort flashing” option. Proceed : 1 - Engine off, ignition off, connect your...
Touran (1T3) – Coming / Leaving Home with fog lamps
Purpose: Enables fog lamps to be used for Coming Home and Leaving Home. Procedure: 1 - Engine off, ignition off, connect your...
Touran (1T3) – Coming / Leaving Home with Xenons / Halogen
Purpose: Activates xenon (or halogen) headlamps instead of fog lamps for Coming Home and Leaving Home. Procedure : 1 - Engine off,...
Touran (1T3) – Coming-Home settings
Purpose : to configure Coming-Home behavior. Procedure : 1 - Engine off, ignition off, connect your official VAG-COM VCDS cable to the...
Touran (1T3) – Corner lights activation
Purpose: to activate cornering lights with fog lamps. Procedure: 1 - Engine off, ignition off, connect your official VAG-COM VCDS cable to...
Touran (1T3) – Corner Lights in reverse
Purpose: to activate the cornering lights with the fog lamps when reversing. Procedure : 1 - Engine off, ignition off, connect your...
Touran (1T3) – Correction of ODB consumption display
Purpose: to correct the fuel consumption display on the on-board computer. Modification only possible on Mid/High range models. Note: modifications affect the...
Touran (1T3) – Daytime running lights off (DRL) with handbrake on
Purpose: deactivates the daytime running lights when the handbrake is engaged. Procedure: 1 - Engine off, ignition off, connect your official VAG-COM...
Touran (1T3) – Deactivate automatic rear wiper
Purpose: to deactivate automatic activation of the rear wiper. Procedure : 1 - Engine off, ignition off, connect your official VAG-COM VCDS...
Touran (1T3) – Deactivate brake pad warning light
Purpose: to deactivate the worn brake pad warning light on the ODB (on-board computer), e.g. if the brake pad has no sensor...
Touran (1T3) – Deactivate ESP
Purpose: to deactivate ESP completely. ATTENTION: Only valid for vehicles from 2012. Procedure : 1 - Engine off, ignition off, connect your...
Touran (1T3) – Deactivate windshield washer indicator
Purpose: to deactivate the windshield washer indicator on the ODB (on-board computer). Procedure: 1 - Engine off, ignition off, connect your official...
Touran (1T3) – Delete belt alarm
Purpose: To suppress the audible alarm and the warning light on the speedometer when driving without a seatbelt. Procedure: 1 - Engine...
Touran (1T3) – Disable Bluetooth connection beep
Purpose : Disables the beep when a device successfully connects to the car radio's Bluetooth. Procedure : 1 - Engine off, ignition...
Touran (1T3) – Disable plate light control (ODB LED error)
Purpose: Disables license plate light control. Useful when installing LED bulbs without resistance or for error prevention. Procedure: 1 - Engine off,...
Touran (1T3) – Door lock/unlock confirmation (beep)
Purpose: Enables vehicle lock/unlock confirmation with beeps (with alarm) Procedure: 1 - Engine off, ignition off, connect your official VAG-COM VCDS cable...
Touran (1T3) – Electronic differential lock (XDS)
Purpose: to activate the electronic differential lock (XDS). The electronic differential lock (XDS) is an extension of the well-known EDS function. However,...
Touran (1T3) – Flash mode lights during emergency braking
Purpose: activates the brake/turn signal lights in flash mode during emergency braking. Procedure : 1 - Engine off, ignition off, connect your...
Touran (1T3) – Full sunroof opening with remote control
Purpose: Allows the sunroof to be opened fully when opening with the remote control. Procedure: 1 - Engine off, ignition off, connect...
Touran (1T3) – Hill Hold Control
Purpose: to activate Hill Hold Control. Hill Hold Control maintains brake pressure for a few seconds after prolonged application of the brake...
Touran (1T3) – Lower passenger mirror when reversing
Purpose: automatically lowers the passenger mirror when reversing. The mirror adjustment knob must be in position“R” for the passenger mirror to lower...
Touran (1T3) – Memory for heated seats
How it works : When you switch on the heated seat(s), as soon as you remove the key from the ignition the...
Touran (1T3) – Modify power steering hardness
Purpose : to adjust the hardness of the power steering for a softer or harder steering wheel. Proceed : 1 - Engine...
Touran (1T3) – Needle check
Purpose: activates needle sweep when the car is started. (Needle Sweep) Procedure: 1 - Engine off, ignition off, connect your official VAG-COM...
Touran (1T3) – Oil temperature on the ODB
Purpose: to activate the Oil Temperature Display in your Grand ODB. Some cars don't have this sensor available in the ODB, including...
Touran (1T3) – OPS speed camera display on car radio screen
Purpose: Enables the display of OPS speed cameras on the car radio screen. Please note: The vehicle must be equipped with a...
Touran (1T3) – Selective door unlocking
Purpose: Used to set up selective door unlocking. When unlocking the vehicle, only the driver's door is unlocked. To unlock all doors,...
Touran (1T3) – Sound reduction on OPS activation
Purpose: Automatically lowers speaker volume when OPS is activated. Procedure : 1 - Engine off, ignition off, connect your official VAG-COM VCDS...
Touran (1T3) – Speed limit display RNS 510
Purpose : to display the speed limit on the RNS 510 navigation screen. Procedure: 1 - Engine off, ignition off, connect your...
Touran (1T3) – Start/Stop deactivation
Purpose: to disable Start and Stop completely. Only compatible with Gateway 7N0! Temperature deactivation method. Proceed : 1 - Engine off, ignition...
Touran (1T3) – Tear Wiping
Purpose: to activate the windshield wipers once more after using the windshield washer, in order to remove any remaining water from the...