Purpose: Eliminates ODB error after LED reversing light installation.
Watch out! There are 4 lines of coding to do here.
Proceed :
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to
the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
Line 1:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on“Adaptation – 10”.
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose“Leuchte29RFL RA64 – Lasttyp 29”.
7 – On the same page, there is a second drop-down menu at the bottom
of the page.
Select“43 – allgemeine LED” and confirm.
Line 2:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on “Adaptation – 10”.
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose“Leuchte29RFL RA64 – Dimmwert AB29”
7 – On this same page, there is a second drop-down menu but towards the bottom
of the page.
On this, choose “127” then validate.
Line 3:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on“Adaptation – 10”.
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose“Leuchte28RFL LC11 – Lasttyp 28”.
7 – On the same page, there is a second drop-down menu at the bottom
of the page.
Select“43 – allgemeine LED” and confirm.
Line 4:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on “Adaptation – 10”.
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose “Leuchte28RFL LC11 – Dimmwert AB28”
7 – On this same page, there is a second drop-down menu, but towards the bottom
of the page.
Select “127” and confirm.