T-Cross (C1) – Light Assist activation

Purpose: to activate the high beam assistant for vehicles with Sign Assist and/or Lane Assist options.

Vehicle must be equipped with 3Q0 camera


Watch out! There are 4 lines of coding to do here.


Proceed :
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to
the computer, then plug the other end into your vehicle’s diagnostics socket.

2 – Switch on the ignition and run the VCDS program.

Line 1:

3 – Click on“Select”, then click on“09 – Cent. Elect.”.

4 – Click on“Security Access – 16” then enter the code“31347”.

5 – Click on “Adaptation – 10”.

6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose“Fernlicht_Assistent-Menu control high-beam assistant”.

7 – On the same page, there’s a second drop-down menu at the bottom
of the page.
Select“present” and confirm.

Line 2:

3 – Click on“Select”, then click on“09 – Cent. Elect.”.

4 – Click on“Security Access – 16” then enter the code“31347”.

5 – Click on“Adaptation – 10”.

6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose“Fernlicht_Assistent-Menu control high-beam assistant factory setting”.

7 – On the same page, there’s a second drop-down menu at the bottom
of the page.
Select“present” and confirm.

Line 3:

3 – Click on“Select”, then click on“09 – Cent. Elect.”.

4 – Click on“Security Access – 16” then enter the code“31347”.

5 – Click on“Adaptation – 10”.

6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose“Fernlicht_Assistent-Extended_Fernlichtsteuerung”.

7 – On this same page, there is a second drop-down menu, at the bottom
of the page.
On this menu, choose “AFS: FLA: BCM high beam” or “AFS: FLA: high beam over AFS”, then confirm.

Line 4:

3 – Click on“Select” then click on “.A5 – Frt Sens. Drv. Assist“.

4 – Click on“Security Access – 16” then enter the code“20103”.

5 – Click on“Coding – 07” then click on“Long Coding Wizard”.

6 – Select byte“21
Then, in the“Bit 5-7” drop-down menu, select“20 AFS_coding_Light_Assist, High_Beam_Assist”.

Translate »
error: Content is protected !!
Enable Notifications OK No thanks