Purpose: to share the connection received by the car from a phone or 3G key in Hostpot. Only for Discover Pro V1.
Watch out! There are 4 lines of coding to do here.
Proceed :
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
Line 1:
3 – Click on“Select” then click on“5F – Electr. information”.
4 – Click on“Security Access – 16” then enter the code“20103”.
5 – Click on“Adaptation – 10”.
6 – On this page, at the top, there is a drop-down menu.
In this drop-down menu, choose“WLAN”.
7 – On this same page, there is a second drop-down menu at the bottom
of the page.
On this menu, choose the value“ON”.
Line 2:
3 – Click on“Select” then click on“5F – Electr. information”.
4 – Click on“Security Access – 16” then enter the code“20103”.
5 – Click on“Adaptation – 10”.
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose“Vehicle configuration-WIFI_Hotspot”.
7 – On this same page, there is a second drop-down menu at the bottom
of the page.
On this menu, choose the value“ON”.
Line 3:
3 – Click on“Select” then click on“5F – Electr. information”.
4 – Click on“Security Access – 16” then enter the code“20103”.
5 – Click on“Adaptation – 10”.
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose“Vehicle configuration-UPnP”.
7 – On this same page, there is a second drop-down menu at the bottom
of the page.
On this menu, choose the value“ON”.
Line 4:
3 – Click on“Select” then click on“5F – Electr. information”.
4 – Click on“Codage- 07” then click on“Long Coding Helper”.
5 – Select byte“15”
Then check Bit“4”.
6 – Select byte“24”
Then check Bit“3”.