Purpose: Disables the burnt-out bulb display on the ODB. After adding LEDs, your on-board computer may indicate that the replaced bulb is out of order.
Please note that this depends on your power plant. Save the coding if it doesn’t work to reset it.
Procedure :
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Coding 07”.
5 – Select the “0” module and click on “Long Coding Helper”:
Byte 18:
In binary code, if 0000000 is set to 0, replace with 0010101 so that the value in the byte changes to 15.