Purpose : to set door lock confirmation when using the remote control.
Proceed :
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
Line 1:
3 – Click on “Select”, then click on “46 – Comfort Module”.
4 – Click on “Adaptation – 10”.
Canal 10
Set value to 0 (no confirmation)
Set value to 1 (confirmation with flashing lights)
Set value to 2 (confirmation with beep/horn)
Set value to 3 (confirmation with flashing lights + beep/horn)
Line 2:
If the adaptation channel is not activated.
3 – Click on“Select”, then click on“46 – Comfort module”.
4 – Click on“Coding – 07” then on “Long Coding Helper”.
Byte 11:
Bit 2: Check “Locking Confirmation (Blink) via Remote Control” (confirmation with flashing lights)
Bit 3: Tick “Locking Confirmation (Horn) via Remote Control” (confirmation with Beep/Horn)
