Purpose: to activate voice control on the RNS 510 (SDS).
ATTENTION: RNS 510 firmware must be version v2660.
Activating voice control brings up the “Voice control” menu in the RNS 510’s SETUP menu.
Procedure:
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition, then run the VCDS program.
Line 1:
3 – Click on “Select”, then click on “Select”, then click on “Select”. Procedure: 1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostics socket. “37 – Navigation”.
4 – Click on“Coding 07”.
5 – Select the “0” module and click on “Long Coding Helper”:
Byte 3, check the box for“Bit 1: Microphone Diagnostics active”.
Byte 7, uncheck the box for“Bit 1: Voice Control inactive”.
To install the microphone, connect the microphone lead to the rear of the RNS 510. Connect to pins (Mic-)C1 and (Mic+)C7.
