Purpose: activates the brake/turn signal lights in flash mode during emergency braking.
Procedure :
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
Line 1:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Security Access – 16” then enter the code“31347”.
5 – Click on“Adaptation – 10”.
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose“Aussenlicht_Blinker – Emergency alert blinken”.
7 – On the same page, there’s a second drop-down menu at the bottom
of the page.
Select“Active” and confirm.
OR
Line 1:
3 – Click on“Select”, then click on“09 – Cent. Elect.”.
4 – Click on“Coding 07”.
5 – Select the “0” module and click on “Long Coding Helper”:
Byte 16:
Bit 1: Check “Emergency Brake Flashing via Brake Light active” (to activate brake lights)
Bit 2: Check “Emergency Brake Flashing via Turn Signal active” (to activate turn signals)
