Purpose: to add Offroad mode to the Easy Connect MIB V2 screen with navigation.
Warning! There are 3 lines of coding to do here.
Proceed :
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
Line 1:
3 – Click on“Select” then click on“5F – Electr. information”.
4 – Click on“Security Access – 16” then enter the code“20103”.
5 – Click on“Adaptation – 10”.
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose“Car_Function_List_BAP_Gen2-compass_0x15”.
7 – On this same page, there is a second drop-down menu at the bottom
of the page.
On this menu, select“active” and confirm.
Line 2:
3 – Click on“Select” then click on“5F – Electr. information”.
4 – Click on“Security Access – 16” then enter the code“20103”.
5 – Click on“Adaptation – 10”.
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose“Car_Function_Adaptations_Gen2-menu_display_Compass”.
7 – On this same page, there is a second drop-down menu at the bottom
of the page.
On this menu, select“active” and confirm.
Line 3:
3 – Click on“Select” then click on“5F – Electr. information”.
4 – Click on“Security Access – 16” then enter the code“20103”.
5 – Click on“Adaptation – 10”.
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose“Car_Function_Adaptations_Gen2-menu_display_Compass_over-threshold_high”.
7 – On this same page, there is a second drop-down menu at the bottom
of the page.
On this menu, select“active” and confirm.
Additional line if OFF Road not activated :
Car_Function_Adaptations_Gen2
menu_display_compass: change the value to “activated” [Standard: “Not activated”]
menu_display_compass_over_therhold_high: change the value to “activated” [Standard: “Not activated”]
menu_display_angle_of_slope: change the value to “activated” [Standard: “Not activated”]
menu_display_angle_of_slope_over_threshold_high: change the value to “activated” [Standard: “Not activated”]
Car_Function_List_Bap_Gen2
compass_0x15: change the value to “activated” [Standard: “Not activated”]
compass_0x15_msg_bus: change the value to “Comfort data bus”
angle_of_slope_0x24: change the value to “activated” [Standard: “Not activated”]
angle_of_slope_0x24_msg_bus: change the value on “Comfort data bus”
