Purpose : to set the speed at which the high beam assistant is activated and deactivated.
Proceed :
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
Line 1 (Deactivation) :
3 – Click on “Select”, then click on “20-High Beam Assist”.
4 – Click on “Adaptation – 10”.
5 – Select Channel 01 “Low Beam Speed Threshold” from the list of values
6 – Enter the desired deactivation speed (between 5 and 100km/h)
Line 2 (Activation):
3 – Click on “Select”, then click on “20-High Beam Assist”
4– Click on “Adaptation – 10”.
5 – Select Channel 02 “High Beam Speed Threshold” from the list of values
6 – Enter desired activation speed (between 5 and 100km/h)