Purpose: displays speed limit signs on the ODB (Onboard Computer). (Sign Assist)
The vehicle must be equipped with the 5Q0 camera (A3 8V phase 1, the camera is located at the top of the windscreen, level with the rear-view mirror, in the shape of a triangle).
Warning! There are 6 lines of coding to do here.
Proceed :
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to
the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.
Line 1:
3 – Click on“Select” then click on“5F – Electr. information”.
4 – Click on“Security Access – 16” then enter the code“20103”.
5 – Click on“Adaptation – 10”.
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose“Vehicule function list BAP-traffic_sign_recognition_0x21”.
7 – On the same page, you’ll find a second drop-down menu at the bottom of the page.
On this menu, select“activated” and confirm.
Line 2:
3 – Click on“Select” then click on“5F – Electr. information”.
4 – Click on“Security Access – 16” then enter the code“20103”.
5 – Click on“Adaptation – 10”.
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose“Vehicule menu operation-menu_display_road_sign_identification”.
7 – On this same page, there is a second drop-down menu at the bottom of the page.
On this menu, select“activated” and confirm.
Line 3:
3 – Click on“Select” then click on“5F – Electr. information”.
4 – Click on“Security Access – 16” then enter the code“20103”.
5 – Click on“Adaptation – 10”.
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose“Vehicule menu operation-menu_display_road_sign_identification_over_threshold_high”.
7 – On this same page, there is a second drop-down menu at the bottom
of the page.
On this menu, choose“activated” and confirm.
Line 4:
3 – Click on“Select” then click on “.A5 – Frt Sens. Drv. Assist “.
4 – Click on“Security Access – 16” then enter the code“20103”.
5 – Click on“Coding – 07”, then click on“Long Coding Helper”.
6 – Select byte“1”
Then, in the Bit 0-7 drop-down menu, select“01 Coding_VZE coded”.
Line 5:
3 – Click on“Select” then click on “.A5 – Frt Sens. Drv. Assist “.
4 – Click on“Security Access – 16” then enter the code“20103”.
5 – Click on“Adaptation – 10”.
6 – On this page, at the very top, there is a drop-down menu.
In this drop-down menu, choose“Display end of speed limit symbol”.
7 – On this same page, there is a second drop-down menu at the bottom of the page.
On this menu, select“activated” and confirm.
Line 6:
3 – Click on“Select”, then click on“17 – Instruments”.
4 – Click on“Security Access – 16” then enter the code“20103”.
5 – Click on“Coding – 07” then click on“Long Coding Helper”.
6 – Select byte“5”
Then check Bit“2”:“Traffic Sign Recognition installed”.
