Purpose: To activate the reversing camera after it has been installed on the MMI RMC or 3GP.
Procedure:
1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostics socket.
2 – Switch on the ignition and run the VCDS program.Procedure: 1 – Engine off, ignition off, connect your official VAG-COM VCDS cable to the computer, then plug the other end into your vehicle’s diagnostics socket.
Line 1:
3 – Click on“Select”, then click on“19 – CAN Gateway“.
4 – Select “Installation List”
5 – Tick:“6C – Rear View Camera” in the list
6 – Save coding
Line 2:
3 – Click on“Select” then click on“6C – Rear view camera“.
4 – Click on“Coding – 07” then click on“Long Coding Helper“.
5 – Coding:
1030015 = Automatic hitch, with APS+.
1000015 = RVC only
1020015 = APS+, without automatic coupler
1010015 = Automatic hitch, without APS+.
Line 3:
3 – Click on“Select” then click on“5F – Electr. information”.
4 – Click on“Security Access – 16” then enter the code“20103”.
5 – Click on“Coding – 07” then click on“Long Coding Helper“.
For MMI RMC :
6 – Select byte 6
Then set bit 2
For MMI 3GP:
6 – Select byte 7
Then set bit 1
Restart MMI
Hardware upgrade :
The camera’s video cable is connected to the infotainment control unit. This is installed in the glovebox.
The 2 pins of the reversing camera are used in the 12-pin quadlock (blue). Usable cable set: Part no. 000 979 009 E
Quadblock Assignment :
Pin 5 = video line
Pin 11 = shielding
